Stihl Ultra or Amsoil Saber

[mdavlee]

Great a new oil thread
View attachment 217703

I can’t stand that stuff. Too strong a smell milling and one of the worst deposits on a piston that I seen. Hard flaky white and gray carbon.

 

[P.M.P.]

I can’t stand that stuff. Too strong a smell milling and one of the worst deposits on a piston that I seen. Hard flaky white and gray carbon.

Switch over got a few tanks through it. Smells good with me. I'll keep an eye out for the pecker traks.

 

[birdmeter]

32x1 red armor for my saws

 

[leadfarmer]

Gfy's......

 

[Deets066]

Gfy's......

Thank you may I have another....?

 

[drf256]

Switch over got a few tanks through it. Smells good with me. I'll keep an eye out for the pecker traks.

I like it too. But I don’t really mill.

I don’t have the experience Mike does, but for regular breakin and cutting, the Motul800 has served me well.

Had issues with it at 30:1 in MT saws though. Did mill with it at 24:1 and it did fine, I didn’t pull jug though.

 

[Lightning Performance]

I went back to 40-1 unless I'm pulling the 60" 32-1. I have to stay with a single ratio for everything.

If you want the best oil imo H1R

Johnson and Rude injection oil mixes well and burns very clean. It has no dye, clear oil.

 

[BlacknTan]

A tip from my dealer when I asked about mix oil....

"Don't overthink it!"

Good advice!

 

[Lightning Performance]

A tip from my dealer when I asked about mix oil....

"Don't overthink it!"

Good advice!

What dealer?
Just the tip?

 

[mdavlee]

H1r protects but I had to drill some carbs to get them rich enough. Not worth it to turn that stuff. It was great still but lube.

 

[Lightning Performance]

H1r protects but I had to drill some carbs to get them rich enough. Not worth it to turn that stuff. It was great still but lube.

You run 32-1 ported...no screens?

 

[Mastermind]

My favorite.

Yamalube 2R

 

[mdavlee]

You run 32-1 ported...no screens?

Yes. 32:1 had one so lean it almost locked up on the 3rd cut in 10” wood.