chisel
Well-Known OPE Member
Hey guys,
never sold anything here but am a long time reader of this site and "the other one". i also sell lots of parts on ebay.
Anyway, I recently acquired this decently clean west German 10mm 044 from a friend that wasn't going to do anything with it. the top end was smoked and was just sitting in his garage.
I sourced a good slant fin cylinder from jockeydeuce and paired it up with a new 10mm meteor from the greek.
I pressure/vacuum tested the saw, new carb kit and she runs great / everything works. the squish is set right at .020 - three bond with no base gasket.
The saw needs a new air filter (sorry i dont have one) and also the tank vent insert that goes in the end of the rubber tank vent hose.
$625 USD shipped.
never sold anything here but am a long time reader of this site and "the other one". i also sell lots of parts on ebay.
Anyway, I recently acquired this decently clean west German 10mm 044 from a friend that wasn't going to do anything with it. the top end was smoked and was just sitting in his garage.
I sourced a good slant fin cylinder from jockeydeuce and paired it up with a new 10mm meteor from the greek.
I pressure/vacuum tested the saw, new carb kit and she runs great / everything works. the squish is set right at .020 - three bond with no base gasket.
The saw needs a new air filter (sorry i dont have one) and also the tank vent insert that goes in the end of the rubber tank vent hose.
$625 USD shipped.
Last edited: