Show off your muffler mods

[Deets066]

I did see all the holes. Lol

What was his name?

 

[RI Chevy]

???
Even though no gut job, it is still a atraight shot out that muffler. No baffles in the way.

 

[Deets066]

 

[StuntCockWelder]

2159

 

[huskihl]

2159 View attachment 166639

StuntCockPainter get fired?

 

[Drptrch]

View attachment 165931 View attachment 165932

Very Kleen !!


Sent from my iPhone using Tapatalk

 

[StuntCockWelder]

StuntCockPainter get fired?

Fact! Lol

 

[Graf]

My brand new 2511t with less than 5 minutes run time on the bench. View attachment 154223View attachment 154224

Did you remove only the kat or entire inner bulkhead?

 

[Dustin4185]

View attachment 165931 View attachment 165932

Is that a 395? I know you did my 395 like that and I love it....until I lay an unprotected finger on it. It sounds great too!

 

[Mastermind]

Is that a 395? I know you did my 395 like that and I love it....until I lay an unprotected finger on it. It sounds great too!

Never touch.....

 

[J. Dirt]

Did you remove only the kat or entire inner bulkhead?

I tossed the whole piece (the middle one in the picture) It’s almost like a can inside a can and when I cut it in half, half of the inner “can” was stuck in the saw side half of the outter “can” so I just left it there.
I ended up just brazing together the top and bottom parts that are in the picture

 

[Graf]

Is it difficult to braze the two parts? Any suggestions?

 

[Moparmyway]

Is it difficult to braze the two parts? Any suggestions?

This is hard to respond to, based on equipment available, and skill of the PIQ (Person In Question)

I'd TIG the two halves together with some silicon bronze filler rod

 

[Graf]

Surely not me lol

Thanks for the infos

 

[J. Dirt]

I’m thinking it’s stainless on this one. I had a heck of a time trying to get it brazed!! I’m thinking @Moparmyway is right on with his answer.

 

[Moparmyway]

I’m thinking it’s stainless on this one. I had a heck of a time trying to get it brazed!! I’m thinking @Moparmyway is right on with his answer.

If it's stainless, I probably wouldnt use silicon bronze though, Id probably run some Hastelloy W or 308

 

[mdavlee]

If it's stainless, I probably wouldnt use silicon bronze though, Id probably run some Hastelloy W or 308

Any of the 308/309/316 will work. 347 would crack easy along with ERNICROMO3.

 

[Mycamaro_68]

Any of the 308/309/316 will work. 347 would crack easy along with ERNICROMO3.

I used .035 MIG wire for my fill rod. Cant remember if it was 309 or 316 though.

 

[MTBoundJoe]

Here's mine. Thanks red97, good stuff and quick shipping.

 

[tickbitintn]

View attachment 167216 Here's mine. Thanks red97, good stuff and quick shipping.

Dang that was fast!! [emoji3526]

Sent from my XT1635-01 using Tapatalk