WANTED Right angle fordom

[paragonbuilder]

Pics ?
That picture I posted is a 346 jug. Just about impossible to get a corner on the intake side of the secondaries, even with the CC MC182

I'll get some pics later. I'm bringing wood in and prepping for plowing. It's snowing again

 

[Sty57]

Cutoff wheels work ok in dual port jugs, but I haven't seen a quad port that the wheel will fit in.

That's what I was wondering.

 

[Moparmyway]

I'll get some pics later. I'm bringing wood in and prepping for plowing. It's snowing again

Here too, been snowing/sleeting/raining and turning into ice all day. Real slippery now.

 

[mdavlee]

I've done a few 372 jugs with cut off wheels before I had a right angle. I had to wear them down to fit.

 

[paragonbuilder]

Pics ?
That picture I posted is a 346 jug. Just about impossible to get a corner on the intake side of the secondaries, even with the CC MC182

 

[T.Roller]

What model is that

 

[paragonbuilder]

What model is that

It is a foredom right angle. I'll have to check the model number. But like I said earlier, they are really easy to burn up.

 

[wcorey]

Hey Dan, not sure how it's interfaced to the foredom lower end but this one looks pretty similar.

https://www.henryschein.com/us-en/sites/outletcenter/ProductDetail.aspx?partnum=100-5848-N

Even if the interface is different, the internals may be the same. I've also see them pretty cheap on ebay.
I did some fairly thorough research for a cheaper alternative to the cc specialty (before buying one) and these were about as close as I came. There are alternatives but not cheap...

 

[srcarr52]

It is a foredom right angle. I'll have to check the model number. But like I said earlier, they are really easy to burn up.

It's a Foredom 55. I trashed 3 of them before I got a CC 182.