Pioneer 650 help needed

[MS290man]

Could someone who has a Pioneer 650 take a picture of the throttle linkage and post it? Mine is missing and I'm thinking I'll have to just make my own. Anyone who could help me?
Thanks!

 

[p61 western]

@Basher should be able to help you out.

 

[jockeydeuce]

I can get you a pic tomorrow

 

[Basher]

I can get you a pic tomorrow

If Rob can put a pict up I will hold off as my online picture holding account has vanished I would have to take new picts and download them. All the saws from the RA , 600, 610,620 and 650 all used the same simple connection between the throttle lever and the HL carb, I have made a few out in the field from a 2" long finish nail, bend a hook in each end.

 

[MS290man]

If Rob can put a pict up I will hold off as my online picture holding account has vanished I would have to take new picts and download them. All the saws from the RA , 600, 610,620 and 650 all used the same simple connection between the throttle lever and the HL carb, I have made a few out in the field from a 2" long finish nail, bend a hook in each end.

Cool, I didn't know they were the same! I have an RA, I'll look at that. Thanks!

 

[Basher]

Actually the RA is just a sand cast magnesium model of the Pioneer 600, the 600 was the first diecast model that Pioneer made after they moved from Vancouver BC to Peterborough Ont.

 

[67L36Driver]

RA is sandcast aluminum.
Almost left Fat Alice natural finish after cleaning her up.

Heavy old hoe.

 

[Chainsaw Jim]

Hopefully these help.

 

[jockeydeuce]

There you go....That should cover it.