MS460 cylinder ID

[Eagle1899]

Picked up a MS460 a while back. Runs really good but with any used saw you always have to wonder what you got. So, I checked squish trough the spark pug hole and found it to be a very disappointing .038...
Tear down to the jug, pull it off recheck with no base gasket and found a very encouraging reading of .022
While I had it apart I snapped a few pics of the jug. Can anyone ID this guy from the pics? Thanks in advance.

 

[smokey7]

That sure looks to be a aftermarket cylinder to me.

 

[jacob j.]

That sure looks to be a aftermarket cylinder to me.

Yes indeedy...those spots of Nikasil spray in the squish band are a dead give away...

 

[Eagle1899]

No doubt it is aftermarket. I was just hoping for a guess at the brand.

The saw is probably going up for sale and I would like to advertise it as accurately as I can.

 

[jacob j.]

Judging by the numbers on the flywheel side, I would say it's Farmertech.

 

[Iceboy]

Aftermarket for sure and not high quality as it seems.

 

[blsnelling]

Horribly shaped combustion chambers and excessive squish are synonymous with aftermarket cylinders.