Little China Girl

[Stump Shot]

Layout and drilling holes.

 

[Stump Shot]

Tapped for heli-coils. Now it has studs. Pressed impulse nipple in.

 

[MustangMike]

I've never tried a belt sander to sharpen a drill bit. But if they're good enough to sand a cylinder base.....

I was refraining from saying something like that!

 

[MustangMike]

Also, don't know if Randy realized, but my belt sander is just a little hand held job from HF!

 

[Mastermind]

Also, don't know if Randy realized, but my belt sander is just a little hand held job from HF!

Flip it upside down. ...and clamp it to the bench with a c clamp.

 

[Mastermind]

Layout and drilling holes.View attachment 82398 View attachment 82403 View attachment 82404

Looking bad ass Steve.

 

[Wagnerwerks]

Lol. Looks like you guys covered sharpening a bit!

I will add the reverse in a drill grinding method does work well to return a broken bit to uniform sides.... Then you need to sharpen it.

I'm to busy to use a jig.... The lift method is what I was taught, but I usually grind the cut edge and then do another bevel behind it. I find it easier and they cut well. Practice makes perfect. I've broken hundreds of drill bits.

 

[Stump Shot]

POS drill press, made a poor end mill. Thought this would be the neatest way to go. Was going good until the head spun and walked over.




So I went into full Mongo mode, ground it out instead. Took a bit of time, but end result was better.

 

[T.Roller]

Looking good

 

[Mastermind]

Looks like you need a new clutch Steve.

 

[T.Roller]

Looks like you need a new clutch Steve.

 

[Stump Shot]

Looks like you need a new clutch Steve.

Probably, how much this time?

 

[Mastermind]

Probably, how much this time?

Eleventy Billion Shekels.

 

[nickw]

@dall broke it.

How would he even get close to it?

 

[dall]

How would he even get close to it?

I had to fix it too

 

[Stump Shot]

Eleventy Billion Shekels.

And me no where near an ocean...fresh water clam shells OK?

 

[dall]

And me no where near an ocean...fresh water clam shells OK?

rinse them off when your done

 

[Stump Shot]

rinse them off when your done

Picky, picky.

 

[nickw]

I've never tried a belt sander to sharpen a drill bit. But if they're good enough to sand a cylinder base.....

Hey I trim horse hoofs with them.

 

[p61 western]

Bump what's going on with this saw?