Husqvarna 350 rebuild

[Kensie1988]

so I got a Husqvarna 350 for $100 non running as is. I thought it was a decent deal so I went ahead and picked it up.

Now I've started tearing it down for a rebuild and wanted to get some opinions on what route to take

I see a lot of people building them into a 346xp, I'm leaning towards this route and I need to know what all I will need to make this work

I'm currently trying to find a good case for it since the muffler melted the one I have, will the muffler brace fit on all models of the 350?

I think I will also put in new seals while I am down there.

Anything else I might need to add to the list?

 

[BGE541]

Do seals and bearings, then get some good Dirko and throw it together, measure squish and take the bearing cap down to lower it if need be. Get the 346xp intake boot and metal clamp or a 371/372 non X Torque clamp. Trim the limiter tabs, good muffler mod and enjoy.