How To Prevent Chatter When Using A Right Angle Handpiece

[Mastermind]

I told @Tor R I would make a video to help him out with this issue. Here it is....and I hope it helps.

 

[Glock37]

Your not dipping bit in silicone any more ? Damn that sings


Sent from my iPhone using Tapatalk

 

[Mastermind]

Your not dipping bit in silicone any more ? Damn that sings


Sent from my iPhone using Tapatalk

It was getting on the collet and I was having to overtighten it to keep the bit in.

 

[Glock37]

Thats slippy *s-word !


Sent from my iPhone using Tapatalk

 

[Mastermind]

Yes Sir. It is and I have a lifetime supply of it.

 

[Tor R]

Awesome!! Thanks alot Randy
Ill start on that corner from now on

 

[Poleman]

Great video Randy!!! How do those burrs wear grinding the Nikisil in the port openings......some of that is really hard.

 

[Mastermind]

Awesome!! Thanks alot Randy
Ill start on that corner from now on

You're welcome sir.

Great video Randy!!! How do those burrs wear grinding the Nikisil in the port openings......some of that is really hard.

They dull faster than a double cut for sure Rich. I use a diamond file on them and can sharpen them a few times though.

 

[jake wells]

I told @Tor R I would make a video to help him out with this issue. Here it is....and I hope it helps.

you were a sculptor in your previous life.

 

[exSW]

Is the chatter the result of the direction of rotation? So if your bit rotated and cut the opposite direction you'd start on the right side.

 

[Chainsaw Jim]

Usually the chatter comes from the burr making contact with too much material and both directions fight each other with sonic speed. When you hit that corner with a deeper bite from the other way it'll grab too much material and do that. If the burr is spinning the other direction it will chatter on the other side instead.

 

[Canadian farm boy]

Great video Randy, thanks.

 

[David Young]

I'd love to see more of these tip. Thanks Randy