Any interest in my lathes?

[twinstaged]

Toying with the idea of some equipment upgrades. Would need to sell the stuff in my way to do that. I'm located in northeast Ohio. I have a nice small 10 inch Rockwell lathe with tooling and a bigger 16 inch skb lathe.

I've used the Rockwell a bunch for small projects. It's a good size for saw work too. Brand new 3 jaw, has a 4 jaw, Jacobs rubber collet setup that is super slick and accurate, quick change toolpost. The one killer for garage guys is the motor is 3 phase.

The skb is rougher. I got it in a bulk buy of stuff. Done 1 small job on it and it's serviceable depending on the job you need done.

I can post some pictures in a bit if there's interest. Need to get my ass in gear and just get it over with.

 

[tree monkey]

pics and prices

 

[Warped5]

pics and prices

+1

 

[twinstaged]

Asking 1500 for the Rockwell. Power feed and power crossslide. The crossslide nut has some wear that I didn't get around to repairing as it works just fine, but would be an easy fix. Morse taper #2 tailstock 1 1/2 -8 head stock.

 

[twinstaged]

Rest of the pictures. Can make a video or take any other pictures you want to see

 

[twinstaged]

Has a taper attachment too. Didn't have a steady rest when I got it. You'd have an absolute maximum of 24 inches between centers if you ran on the edge.

 

[twinstaged]

Looking to get 1500 from the skb, but I'm open to offers. 7.5 hp 3 phase. Newer 3 jaw. Comes with the tool post but no tooling really. I probably have a good 4 jaw for it. I believe it's a D1-6 spindle but don't quote me I have not had the chuck off to look. I think it's a Morse taper #4 tailstock.

 

[Beavis331]

If you were closer I would jump all over that rockwell!