MontanaTed
Well-Known OPE Member
I have a 2013 562xp I’d like to offer for sale PHO. I got this saw on trade from @laslabjohn a couple years back now. I have only cut a couple of pick up loads with it. Everything has operated as it should for me.
It has had the decomp plugged. I can honestly say I do not know if anything else has been done to it. It ran well for me the two outings I took it on. I cut at about 5000ft +/-.
Overall the saw it in great condition, The muffler is dented but was that way when I got it. Piston still has machine rings on it. I do not have a comp gauge for this size but have no reason to believe it’s low. I bought the 3/4 wrap for it and it has an extra set of dawgs for it. Both handles are included.
Looking to sell out right. Willing to listen to trade offers, would be interested in a 7900/7910; 461r or a 372xp/xpw would prefer non ported but I like chatting so don’t hesitate to make an offer
Asking $425 plus the ride (shipping from MT can range from 45-75 depending where it goes) PHO I stand behind anything I sell and if there’s an issue we’ll work it out. I am open to offers we’ll discuss those in a PM.
I also managed to lose the screw when I took the photo of the piston...smh.
That screw will be replaced prior to shipping.
It has had the decomp plugged. I can honestly say I do not know if anything else has been done to it. It ran well for me the two outings I took it on. I cut at about 5000ft +/-.
Overall the saw it in great condition, The muffler is dented but was that way when I got it. Piston still has machine rings on it. I do not have a comp gauge for this size but have no reason to believe it’s low. I bought the 3/4 wrap for it and it has an extra set of dawgs for it. Both handles are included.
Looking to sell out right. Willing to listen to trade offers, would be interested in a 7900/7910; 461r or a 372xp/xpw would prefer non ported but I like chatting so don’t hesitate to make an offer
Asking $425 plus the ride (shipping from MT can range from 45-75 depending where it goes) PHO I stand behind anything I sell and if there’s an issue we’ll work it out. I am open to offers we’ll discuss those in a PM.
I also managed to lose the screw when I took the photo of the piston...smh.
That screw will be replaced prior to shipping.
Last edited:
