394xp piston. Run it or junk it?

[Huskygasaxe]

 

[huskyboy]

What’s the intake side look like?

 

[Huskygasaxe]

 

[huskyboy]

Looks good! I’d run it.

 

[Stump Shot]

IF you do reuse it, check the rings in the bore first to make sure they don't have excessive wear and are in need of replacement.

 

[beaglebriar]

That's still in beautiful shape. No doubt..run it!

 

[Canadian farm boy]

Looks good! I’d run it.

IF you do reuse it, check the rings in the bore first to make sure they don't have excessive wear and are in need of replacement.

That's still in beautiful shape. No doubt..run it!

I agree with Curly, Larry and Moe.

 

[5000+]

Do the rings have up/down play in the groves? The pics its looks sloppy.

 

[Stump Shot]

I agree with Curly, Larry and Moe.

Thanks Shemp!

 

[beaglebriar]

I agree with Curly, Larry and Moe.

Hey look what the cat dragged in!

 

[Canadian farm boy]

Hey look what the cat dragged in!

 

[jk14]

Fresh set of rings and run that m'fer

 

[Huskygasaxe]

Thanks everyone, I was most concerned about the glossy area on the bottom of the intake side. I will clean it up and certainly reuse it.

 

[huskyboy]

Thanks everyone, I was most concerned about the glossy area on the bottom of the intake side. I will clean it up and certainly reuse it.

Every saw gets a tad bit of wear on the intake like that after the first couple tanks gas. I’d leave it alone, put set of rings on er and work the heck outta it.

 

[danimal]

Ring it and run da dog snot out of it.

 

[MG porting]

View attachment 169138

Run it new rings good to go.