I think it’s real close to OEM power but it’s been a few years since our Echos were stock. I had my saw done by west coast muscle saw and my wife’s was done by huskihl. I’m selling the KNK for $220 including bar and chain. I had them flown over when I got them so my cost is higher.
Yep, I’ve been keeping these a secret from here because I don’t want to come off like I’m advertising but I do have some of these and they do seem worthy. I love the dual bar studs. The muffler is bigger, especially at the port. The passage is probably 60% bigger at the exhaust port. The...
Alibaba is actually pretty easy. Shipping is usually the great unknown. Every time I've bought something the supplier contacted me to offer shipping options then they send me a paypal invoice. Once I pay, they ship. It's not like ebay or amazon where there's no interaction with the seller. It's...
That's the part that was driving me nuts, it can't. But it was. I think I figured out the problem though, at least with the Hyway filters. The media isn't up tight against the tap cap so I think crud was bypassing the media and going right to the tap, up the line and to the screen. If you look...
Ok, since this thread seems to be anything and everything clone saw, i need some help. This is from the screen in the Walbro carb off a G660 Pro. and this is the 2nd time I've had to clean it. This time the screen cavity was completely full. It's sawdust and even what looks like a little stem...
The worst part is that was back the 1st week of February. FT and FedEx are STILL ‘investigating’ what happened. I have no clue if I’ll get my money back or replacement pole or a dry poke in the backside. ☹️
Take the rubber seal off the fuel cap and clean things up. Wrap the groove in the cap with 3M Automotive 06404 Scotch Plastic Tape 471 Blue 1/8" x 36 yds. It’s blue. 5 wraps. Put the seal back on. It also helps seal life if you deburr the fuel hole. I do this to every husky clone through the...
I would totally agree Krooza but putting a sticker on a saw you work on or sell new as a dealer is not only appropriate, it's expected. It makes it much easier for customer to contact you for questions or future needs. Is there something wrong with that? If so you're mission in life will never...
I’ve sold quite a few this year and the only one to give me fits was a 660 running a mill. That’s hard on any saw but I had it set too lean the first time and the 2nd time. I put the 3rd top end on a few weeks ago and went another 1/4 turn out on H and it’s doing fine. And it’s a big bore pop...
That would be nice. I've searched lots of places and never found anything beyond basic tuning guides I'd like to see a trouble shooting guide or a cause & effect guide to tuning. Like if your saw dies when you let off the throttle after a cut, try turning the H screw out a little to richen it...
Do any of you happen to have dimensions for the flippy cap o-rings? And I guess more specifically, the durometer. IPL says the smaller oil cap has a 23x3 and bigger oil and fuel is 25x3.5. I don't know if the bigger dimension is ID or OD but I can measure that. It's the hardness that I can't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.