Search results

Hi, I have an oiler with variable setting, which direction is more oil and which way is less ? The model is a Chainsaw Ryobi RCS3540 also known as: Komatsu Zenoah GZ400 ZENOAH G3800 Redmax/zenoah gz400, gz4000, and gz4500.

thank you for that !!

My chainsaw is this make and model: Ryobi RCS3450, from my research these saws are the same machine: Komatsu Zenoah GZ400 ZENOAH G3800 Redmax/zenoah gz400, gz4000, and gz4500. There appears to be a special tool required to adjust the low and high of the carb. I think its running a bit lean...

thank for that helpful info, I live in east sussex(I see your info says sussex)

Hi, when I stripped the chainsaw down this bearing was dry. Can you please advise if I should put some lubrication on it when I rebuild ? thanks Gavin

Hi, I stripped down my saw becaue the oiler was not working and found the usual stripped nylon gear, I have the new gear, I now have a loads of parts and I should have taken pictures when I was taking it apart, but I did not. Can anyone please help with the service manual for this saw...

Hi, Please can you suggest what kind of lubrication to use on the following items: 1) pull start system (plastic to plastic) 2) nylon oiler gear and metal pump (plastic to metal) thanks Gavin

thank you kindly for writing this up, very grateful ! I have only one question: This pilot hole is the right size to run a 4mm bottom tap in to create the threads... I assume the 4mm hole is the existing hole, I dont need to clean this up ? all I do is tap the M4 thread to the bottom of the...

Hiya, any news yet ? thanks Gav

Hi, any news about the revised thread settings/configuration for the modification? thanks Gavin

Hi, any ideas on when you can get around to it, no pressure, I want to crack on and mod my carb. thanks Gavin

Hi, no that is not it, that is the WG8 carb, but it is the website that has the engine I mentioned. The manufacturer has discovered a new carb and only gave the picture of the carb, they are not disclosing the brand name at this moment. I was hoping someone here could ID it ? thanks Gavin

Good morning, Did I miss the tag event? not sure how the tagging works ? Any news on the revised thread ? thanks & kind regards Gavin

its called a TOP80

Unfortunately I do not have any other info, I have only been given the picture, I do not have the carb in my possession.

Hi, Can anyone please help me identify the make and model of this carb: thank you

thank you kindly Sir I am very grateful. Please tag me regards Gavin

Hi Randy, thank you again for your help, I will be using this on my paramotor, it has a small 80cc engine on it, previously I have been drilling out the high jet to achieve larger diameters, I also use your suggested technique of filling the jet with solder and drilling it out. Taking the carb...

Hi A few more questions illustrated on the picture you provided as below, apologies about my ignorance, I am a metric guy and I think the imperial measurements are possibly tripping me up. thank you kindly for your help. Gavin

Hi Randy thank you for the picture, may I please confirm in the picture I submitted that the hole to the low side well is crossed out as I have indicated in my picture ? Any reason that you are no longer implementing that mod ? thanks and kind regards Gavin