I have a 550 xp mark ii and i see that the oil pump adjusted at max is not oiling the 18 inch bar well.I have done about 15 tanks on it and the bar is like crap,has no paint left on.After little cutting the bar gets very very hot.I am thinking of removing the pin and take one more turn of the pump.
Guys i tried the first ignition coil and the chainsaw starts fine.I tried 0.35mm gap but shuts off at idle,then tried 0.2mm gap and runs very good.But i saw that the max rpm was about 15000 and i decreased to 13500 due to the stihl manual and guess what.....the chainsaw now doesn't start.I tried...
It doesn't have muffler screen.The muffler is clear and and also the exhaust side of the cylinder because every time i remove a cylinder i soda blasting it.The only think that is coming on my mind is the ignition coil gap because i see it very very small after i took it from him.I regaped it...
Guys i took it to a stihl dealer and today i took it back.The chainsaw now starts and works very very good.I paid 20 euros and when i asked him what was the problem he told me that he cannot tell me.Also told me that it wasn't the ignition nor the carb it was my mistake when i teared down the...
Hi
I have an ms270 on bench.The saw came to me with the complaint that is not running good.I pressure tested it and found an air leak at the cylinder sealant so opened it and replaced the sealant, the crank seals,the bearing and the piston rings.The piston is in very good shape.I am trying to...
Hi
I have on my bench a husqvarna 36 that came to me because had starting problem.I found the ignition coil cable was broken and had no spark.I repaired the cable so i started it.When moving the saw up and down goes off so i think it has an air leak.Removing the flywheel for preparing for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.