Search results

Bought this back in the day to fix my 266 not knowing that this is basically a different saw. Its a single ignition, cast key flywheel, fine thread crank. All screw holes good except one top cover hole is wallered out and too big for me to fix with timeserts. New OEM seals, bar studs, and oil...

Ran about a gallon of fuel thru this then switched back to my 365 cylinder when I sold the saw. Carbon is from supertech oil. Bearing and clips are all OEM that came with the kit. Intake side of piston is worn a little more than I thought it would be for just a few tanks of fuel. Bone stock...

I bought this off my neighbor. In 2010 we had a straight line wind event and he bought this new for storm clean up then his son straight gassed it the next year and I bought it from him. I sold off the all the top end parts and was going to rebuild into an OE. I'm a computer carb/strato guy...

This is the saw in this thread: Husky 550xp 545 w/ complete 562xp Intake & Carb | Outdoor Power Equipment Forum (opeforum.com) Built this right before I started farming that year and shelved it. I ended up building a junkpile saw that I used for testing and that saw has been run by my neighbor...

Found this at the bottom of a box of parts. I believe this came off a Husky 394 parts saw I bought about ten years ago. Missing the choke shaft and parts and will need a cleaning and carb kit, I've never used it. There is a NOS choke plate on ebay if your needing that part. Also included is...

My 42 Special grenaded a couple of weeks ago so I'm doing a complete rebuild. My PTO bearing had one of it's metal retainers end up in the crank. Anyone happen to have one they don't need anymore it would be greatly appreciated! Thanks

I'd like to know if anybody knows the differences between the two. They have different Cylinder # 550 # 590 33 05-02 545 # 590 33 05-04 but same piston kit for both 582 64 56-02 Also included is a comparison from the Husky USA site. The 545 has less cylinder...

Lets get the Legalese out of the way: YouTube Saw Builder Warning: No Hyway products were harmed during the modification of this saw. The main reason for this thread is to be able to pull a 18" 3/8 bar & chain on a 50cc with authority in hardwood. I'm a big fan of these new strato saws, they...

I've got a Husky 550xp cylinder that cleaned up but I used the transfer caps and gaskets on another project. Anybody got and extra set available? Thanks, Alan