Search results

Looking for a closed port 55 cylinder

Looking for a easy start black coil for a ps510

Looking for a useable 034 cylinder

Like the add says, looking for a generator/flywheel combo to fit a 357.

Very nice oe 353, all oem as far as I know. Has the plastic intake clamp yet but tunes great and no signs of leakage. Comes with 16” .325 bar and chain that are usueable but Are getting tired. $275 plus shipping from northern MN

Saw would clean up really nice, needs main bearings and a piston. Rod bearing feels tight . Cylinder walls have a little transfer but should clean up, some dings in the dome/squishband area from the injested bearing. Adjustable Oiler but non adjustable high sided carb. $100 and I’ll split...

saw needs main bearings, rod bearing feels ok. Cylinder has some transfer but I believe it will clean up. Air filter holder and top cover is cracked ,as seen in pictures . the top cover screws are stripped but could be tapped and fixed. Make an offer, shipping from 56621

Looking for an NE in good or better condition. All oem and stock, pm me with a couple pics and $$$

Trimmer is a 95’ model, I think part # 503761601 or 537380901 is what I’m looking for. Tia

Just picked this saw up, have too many so this ones got to go. Saw got a new meteor piston, bg was pulled and the muffler is modded. Walbro 199 carb with the correct diaphragm and a hole in the metering cover. Has metal intake clamp. $450plus shipping from northern mn with 18”bar/chain. Not the...

I picked up a really nice 359 case & crank from @J.Walker put a 357xp cylinder on it from a small pin saw that I had. Cylinder had some minor transfer from a plastic intake clamp failure which I sanded clean then double checked with acid. New meteor piston, metal intake clamp, kitted the walbro...

looking for a complete saw, non running to nib.

saw #1 runs , has tiny smear on the exhaust side of piston. Needs a throttle cable, exhaust shield for muffler and it needs the cylinder av mount With ground for the handle. Carb heater is also missing Saw#2 does not run, case has been changed at some point, looks oem Needs: piston, main...

Just picked up this early 357, had a bad decomp and plastic intake clamp. Small smear on the piston but most of it wiped off. I replaced the base gasket and put a caber ring in it when I did the intake clamp. Cylinder was really carboned so I sanded the exhaust port with emery cloth. Break flag...

This saw does have the smaller 13mm connecting rod. Saw was not cleaned before pictures. I replaced the plastic intake clamp with the updated metal clamp. Has the Zama el42 carb, 160lbs of compression. Comes with original 20” bar and chain. $400 plus shipping from northern mn

Really nice 026 with non adjustable carb. Saw was not cleaned before pictures, it has some pine pitch on it. Compression 170-175 psi, saw does everything that it should. Will come with 16” 3/8 setup. $275 plus shipping from northern mn

Looking for a useable oem rewind for a 385, just the cover or everything. Thanks

looking for a 357 piston that will fit an 01 13mm rod

looking for a useable o.e.m. Cylinder, Thanks Josh

I recently found a really clean 390 so this one has to go. I replaced the starter pulley and the oil hose. Saw is all oem, muffler is dented and one top cover clip is missing. Previous owner removed the base gasket and used what looks to be red rtv. Compression around 160psi. Starts, idles, oils...