Search results

What I find pretty odd is the number of forums that have been bought recently and changed to the same forum software. These are just the few that I know of. One even had a REALLY small number of posts per day. Sometimes a week would go by with no posts. I know of 4 or 5 forums that have changed...

I know it isn't a chainsaw, but do y'all know if all 309s had the same ignition coil?

Would the timing being off cause a saw to run rich and lack power? After messing with this one for a while I finally got it to start at just 1/4 turn out on the high and low and that was after I adjusted the metering arm to slightly below even with the floor of the carb.

They FINALLY shipped the parts I ordered for my Shindaiwa 300s so hopefully I can get it running soon. It sure is a lightweight little rear handle saw.

So how small of a bar is too small for any given saw? Or is there such a thing?

Picked up this little 280E yesterday. Hopefully won't be too hard to get her running.

Like a Jumbo shrimp. Lol

Yeah sarcastically speaking.

With quality OEM parts like this, why would I ever try aftermarket?

It is definitely the locating pin. As to how that happened, it beats me. Weird

I planned on getting it running and selling it, but I might just sell or trade it as it is. I have too many projects. Lol

Like I said cyl isnt bad at all

Yeah, I'm kinda pissed. I didn't plan on needing a hard to find piston. This is a new one on me. Cyl looks good, but I can dang near get a 575 piston and cylinder for the price of a 570 piston

Now I need a piston for my 570XP

So what do y'all consider a small saw? 50cc is decent sized around these parts. Not too many 70s running around. So a 30cc is small to me. 40-45 is about average.

Almost complete saw with a good engine. Spark plug wire was cut and is missing an air filter housing and trigger assembly. $50 plus shipping or trade for a similar condition husky 350, 55 or Stihl 028, 026, ms250,

I also found 3 cranks, and a usable piston/cylinder. they just need a slight clean up. I'll include them for $200 shipped to the lower 48 States

I like that case!

No, I can work with you on it. Just trying to get a little cash for other projects.

I forgot to mention I am open to trades if you have a couple husqvarna 350s or 55s parts saws laying around.