High Quality Chainsaw Bars Husqvarna Toys

Search results

  1. K

    Snapper brushcutter Model 410

    Anyone know where I can find a throttle cable for an old Snapper Model 410 brushcutter with a Nikki carb ?
  2. K

    Stihl 036 Carb Options

    Can you still rebuild/repair HK43B or C3a S39B carbs,,what would you charge ? I have 2 with new kits in them but they are both giving same results,saw does not have much power, I could not ultrasound clean them, just carefully sprayed the passages, ? I know this is an old post but looking for...
  3. K

    Briggs choke shaft

    . there is a briggs emblem etched on the side of the cyl block with some numbers is that it ? No model,type code etchings ?
  4. K

    Briggs choke shaft

    . It says Briggs, has alot of briggs stickers on it.
  5. K

    Briggs choke shaft

    . I know how to get the choke plate and shaft out but how do I order the right choke shaft without the eng model number?, I looked in all the recommended places and nothing on the stickers either other than ser # and family numbers.
  6. K

    Briggs choke shaft

    see if this helps
  7. K

    Briggs choke shaft

    No I'll try and post a pic
  8. K

    Briggs choke shaft

    Can't find model number, book says model 100000-130000,, looking for info on how to remove and replace the cheap plastic choke shaft ,,
  9. K

    Snapper rear engine rider gas cap

    I need a gas cap for a 7057243YP (the plastic tank with the odd shape that just slips into a bracket,no fasteners) the cap with the vent screw. Don't have a model number of mower, its a different chassis,engine . Any help is appreciated.
  10. K

    011 carb rebuild fail

    I replaced nozzle check valve, no difference, I give up, will save saw for salvage
  11. K

    011 carb rebuild fail

    ? It seems like it does allow air flow both ways, hopefully they're not obsolete, I'll try to find one, thanks again
  12. K

    011 carb rebuild fail

    / Thanks I'll try that next time I'm out in the shop.
  13. K

    011 carb rebuild fail

    / welch plug has been replaced and is not loose, still not to clear on how to do the press vac test and how it affects the hi side circuit.
  14. K

    011 carb rebuild fail

    So is the main nozzle under the large welch plug or the small one?
  15. K

    011 carb rebuild fail

    Thanks for the quick reply,Where is the nozzle check valve?
  16. K

    011 carb rebuild fail

    WT 29,Cleaned all ports twice with spray carb cleaner, installed rebuild kit, set float lever with W gauge, re-installed, idles ok, set H and L screws to 1-1/4 turns out, H screw adjustment does not make any difference, r&r'd again, cleaned H passage again, re-installed no difference, anyone...
  17. K

    Snapper rider re-power

    Got it running,and it looks like there is a diode in the harness that went to the briggs, I just need to verify that it charges.,
  18. K

    Snapper rider re-power

    the exhaust is in image 20181230_115254.jpg under the duct tape
  19. K

    Snapper rider re-power

    tec formula XL/C mod ohv125 203006E (H) family YTPXS.3582AB displ 358 DEMO311 D
  20. K

    Snapper rider re-power

    Hope theses pics help
Top