Search results

Hey guys, bought my first ported saw used in March and have been running it hard falling and processing for my sawmill here ever since. I haven’t dealt directly with Walker’s so I can only speak about the quality of work that was done to my saw. The saw has a pile of time on it. Ports are very...

Probably the cleanest 65L in existence. Ha ha. Has functioning brake too. Usually starts first pull and has very very little time on it. It had a bad fuel line on it when I got it. I replaced it with one from a 288/2100 and it worked perfectly. Very nice little saw, hard to upgrade to a better...

Selling my two most collectable saws. Already sold the 2101, may as well let these go too. My sawmill requires more money into it to get it up and running so I’ve got to part with these guys. The 1100 runs and oils really well. It has good compression. 24” Windsor bar and 404 semi chisel chain...

anyone got any news? I’m dying to get my hands on one...

hey guys, I have a 359 I’ve been running a lot, it’s my do everything saw at my sawmill. I use it for falling with a 24” bar and on the landing with s 20” bar. I’ve done the base gasket delete and some muffler mods and it’s much gutsier than stock. It’s a joy to run, sips fuel and I really like...

Hi, I'm Brandon and I have a milling addiction! Ha ha. Would anyone be opposed to me doing a thread in milling on our saw mill build? I haven't ever really seen anyone post about sawmills on OPE, just CS milling, and am wondering if you guys would enjoy a build something from nothing thread?

I started collecting 2100s last year after a friend woke up my interest in chainsaws. My dad was a faller up here and he loved 2100s and swears they are one of the best saws ever built. So I decided to start collecting all the variants and a year later here is the 'completed' collection. Left...

What are you guys using for guide rails? I need to build a new set for doing boards up to 16' long. I need to use them for every pass as well. Any ideas?

anyone else doing this? I've been asked to make a spruce tabletop by cross cutting a slab off a spruce tree. Wondering if anyone else is doing this or can give me advice on drying cookies so they don't split etc.

Says she really liked it and that my 44 husky is hers when I get it back. Gonna have to buy her some pants and boots now, she's like 120lbs and I'm 240 so mine do more harm than good on her. She did good for the first time ever running a saw. Got about half a load before she powered out...

Well, I have a rock solid four saw team for my hobby work and firewood harvesting now (44, 359, and two 2100s, one permanently on a mill) and now I need to upgrade some of my other gear. I bought a few cheap wedges and a hatchet with a claw built in for pulling nails (thought it would be handy...

Selling three saw: Poulan 4218 /w 16" bar and chain. Fairly low houred saw. Runs exceptionally well. I did a minor muffler mod on this one and it really picked it up. Dressed the bar recently and it has a new semi chisel chain. $100 Partner s55. This one needs some love. It runs very well...

So I have an MS 390 here that runs fine for five or so minutes and then acts like it runs out of fuel. I've pressure/vac tested each of the lines and tank as well as the engine itself. Everything seems well. The pulse line is good, fuel line is good and so is the tank breather. It has strong...

We had a bit of a get together with a few of my friends and our kids out in the hills today. Kids had a blast playing in the snow and building forts in the sticks. We had a bit of fun with our saws. On hand we had my 2100 husky and Dolmar 114, a buddies 075 and ms170, md another friends 455...