Search results

Back up. 900 and the ride.

Buy a green one from Huskihl or go to the unlimited.

Stihl MS661

SPF

XS ported 394 for long bar. I have only ran the saw a few tanks to do some long bar work…motor pulls and pulls like you would expect out of a Kevin saw. If I recall correctly had some new parts installed during the build but I need to confirm with Kevin. $875 and the ride PHO.

I would guess mine was the 3rd but who knows.

Hoping to be there Friday afternoon through Saturday. Try and bring a fun saw or 2. If we get bored Kev I could use some more poplar wood for chopping :beer-toast1:

Have a flywheel, coil, and carb that all come off a running saw together. This is what was on the 661 stroker originally before we swapped to non mtronic. I don’t have much to go on price wise…only eBay. 150 plus the ride for everything seems a decent clip under those prices. If I am off base...

Small world…been there a few times. I wouldn’t know until I boxed it. Shoot me a pm with your address and we can figure something out. We can cap it at something if you want. On the chains I have a ton of 404 so I can make almost anything. The ones I have now are full chisel and 1 is square. I...

It is .404 .063 with 111 Drivers. They do make a few different adapters which is what we were talking about above. Cannon has a few available and there may be others. http://www.cannonbar.com/wp-content/uploads/2019/06/8.-Adaptor-Plates.pdf...

Actually found another chain so it will have 2 chains with it.

Eh I didn’t have the best of luck with those springs either but in the end they did work. I ran it on my 084 I had awhile back so I didn’t really have to use it on my 3120. Those springs but a pc that’s the same width the whole diameter would work well.

Stihl big mount cannon superbar. Comes with the chain shown. Bar doesn’t have a ton of time on it. .404 .063 $225 and the ride. PayPal

https://youtu.be/NX4zZW9FxLY

https://youtu.be/bPWJ1rfn_a0

$1,025 shipped in lower 48

Ya I didn’t plan on it but that Solo694 didn’t sell. Gotta raise a few funds.

He knows it well…saw originally came from him.

Have a nice rebuilt 066 non decomp saw ported by Tony in Australia. Has the good non decomp top end on it. Saw has the 288 piston, 880 tapered pin, and the unlimited coil (can see it used to be a red light). He rebuilt the bottom end of it when he did the porting with all OEM parts. 2 bar nuts...

Those are all semi chisel?