Search results

Nice, low usage 440. Runs well, I think it may need a new fuel cap or at least an o ring, noticed it seeping recently. Was originally a half wrap saw. All parts OEM to my knowledge. $450 shipped to the lower 48. Will be sold to first pm sender.

Number are right. Rechecked everything this morning. I may have kissed the floor of the transfers but definitely not enough to account for the gap between the crown and floor at BDC. I used a cone burr for the upper transfers. It was tight but I was careful. What burr do you use on these? Not...

Sent from my iPhone using Tapatalk Pro

Yes Sent from my iPhone using Tapatalk Pro

101 126 75 Sent from my iPhone using Tapatalk Pro

I appreciate the input. I thought the transfers looked huge when I was done. Wheel is still on the saw. Gonna recheck for my own piece of mind. Sent from my iPhone using Tapatalk Pro

I triple checked it, checked the wheel and triple checked it again. I’ll go check again. Sent from my iPhone using Tapatalk Pro

The top pic was my first attempt with the right angle. I put a little divot in the floor of the transfer so I just blended it a bit. The other side I was super careful and the floor was untouched. Piston crown at BDC Sent from my iPhone using Tapatalk Pro

Not really a “restoration” but a rebirth. Bought this 12” jointer for like 100$. The company hasn’t existed since 1910 ish I believe so this jointer is 110-140 years old. Oh had an enormous cutterhead with only two knives. The motor was long gone. Tables were flat and had all the modern...

Transfers at 118 Sent from my iPhone using Tapatalk Pro

Time to get to work Sent from my iPhone using Tapatalk Pro

WTB flywheel side case half for an early short case 066, or complete crankcase. Thanks for looking. Jeremiah Sent from my iPhone using Tapatalk Pro

Thanks for the explanation. Really helped clarify the rational behind the numbers. On the exhaust roof I just removed the plating. I find it easier to sand and polish that way. I appreciate the offer but I decided to order the CC specialties right angle handpiece. Already got it all marked...

Thanks for the feedback Al. I made a cutter for the chamber with the same radius as the piston. I only widened the intakes a few millimeters and mostly on the exhaust side. Really just knocking off the corner. Here is my exhaust. I pretty much left the factory shape. Just squared up the...

Took a break from chainsaw forums and tinkering. Still use saws everyday but had too many other things going on to play with them. Bought myself a new ms461 last week and got the bug again. Had this 026 I bought a couple years ago still on my bench. Top end was lightly scored so I decided to do...

Let’s see some more pics close up and deconstructed. Sent from my iPhone using Tapatalk Pro

I personally wouldn’t use it but I’ve taken apart several concrete saws that looked just like that and seemed to run fine. Sent from my iPhone using Tapatalk Pro

Just got mine in the mail from Dan. Haven’t had a chance to play with them yet. Sent from my iPhone using Tapatalk Pro

I’ll take that muffler mike. Jeremiah. Sent from my iPhone using Tapatalk Pro

Should’ve combined shipping hahah, oh well. Let me know what I owe you for shipping. Thanks Kyle! Sent from my iPhone using Tapatalk Pro