360 pro $275powerhead only plus shipping. All OEM. Opened muffler under deflector. Removed base gasket, sanded cylinder to set squish at .020". Advanced timing .020". New seal in flywheel side was a very hard to find leak. New fuel line, carb kit installed. The covers are wet sanded and...
Looking to sell 49cc ms260, Stihl 18" bar and chain. Saw is pressure and vac tested. Has new tecomec piston. Muffler moded and matched to cylinder. Has OEM base gasket. Lscrew only carb. Compression is around 155 at 4 tanks. $220 plus actual shipping.
Rebuilt 600p. All oem parts. Replaced crank seal, intake boot, piston, gaskets. Bar has been used for testing only. Modified Stihl mount, uses 3/8 .058 72dl chains. Has a solid stainless Stihl to echo bar adapter. Muffler outlet has been opened. Buyer to pay shipping. $235.
Look to sell this dolmar 115i with bar and chain. Nice lighter saw with good power. Muffler was opened up some inside and louvered on side. $250 plus shipping.
Sent from my XT1585 using Tapatalk
Mike Lee ported this 371 with OEM 365 top end. It has after market clutch cover with side adjuster. The carb is off a 372xt. Need to reduce saws. House is under contract. 20" bar with 3/8 .050 chain. Looking for $550 plus shipping.
Sent from my XT1585 using Tapatalk
Looking to sell some lightly used petzl equipment. There is a braking descender, hand ascender and rope clamp. $100 plus shipping. I am not well versed in these so if you are please chime in.
Selling some in prep for a move . D024 mount 10mm slot .058 chain. New bar sharp chain. Fits some Olympic and older jred with no mods. Could fit Stihl with mods or husky with loose fit or spacer. $40 plus shipping for combo.
Looking to sell a 2153 with 18" .325 bar and chain. Saw has 150 comp. Pics of cylinder and piston were as purchased. Andy ny15 picked this one up for me. I modded the muffler and bypassed the cat. Has Sierradmax custom stainless spikes. Saw leaks some oil but oils the chain fine. Would like...
Looking to sell this grinder I picked up. I had to remove the light as the socket was bad. I will include in the box. The motor was taken apart at that time and the inside cleaned. There is no stand. The one it is on is for my other grinder. Figure 25lbs for shipping. Would like $300 plus...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.