First 2 man saw

mirage · Dec 1, 2019

msellers said:
The pistons are soaking to start getting the saw freed up from sitting for years. Hope I can get it running again in all it glory.
Mike

What are you using to soak the pistons?

Al Smith · Dec 1, 2019

You can shake a piston loose if it's up above the ports using an adapter made from an old plug and a grease zert .Fill a grease gun with motor oil ,it will shake it .You only have to move it about 1/8" to break it free usually .

mirage · Dec 3, 2019

I got a engine off a Titan saw . The piston is stuck. I have soaked it down with the aft and acetone. It has worked some . Looking at the piston through the exhaust port it has a lot of rust and crud in it. Would it be ok to put it in the glass bead cabinet and clean it up before I try and move the piston. Thanks

Basher · Dec 11, 2019

I would not recommend that on an aluminum piston, better to use evapo rust or even WD40 and a plastic scraper. Just my 2 cents for what its worth.

WKEND LUMBERJAK · Dec 15, 2019

Nighthunter said:
Not to derail the op's thread is there any videos of such a existing chain

@sawnami may have some

sawnami · Dec 15, 2019

WKEND LUMBERJAK said:
@sawnami may have some

Already have the DO-100 posted on here Kenneth.

Sent from my SM-T900 using Tapatalk

First 2 man saw

mirage

Super OPE Member

Al Smith

Here For The Long Haul!

mirage

Super OPE Member

Basher

Pinnacle OPE Member

WKEND LUMBERJAK

Here For The Long Haul!

sawnami

Here For The Long Haul!

Similar threads