SOLD Timberline Sharpener

Wolverine said:

I’ve had one for several years. These are not the fastest method but like mentioned, they make an absolutely razor sharp, almost stropped edge. Every cutter is the exact same length and angle when finished. I still use it for family and friends who use round.
GLWS.

Click to expand...

beaglebriar said:

I chuck the carbide bits up in a little 12v drill. Makes it much faster but it's hard on the aluminum inserts. Gonna try to sleeve a set with steel (either carbon or stainless).

Click to expand...

Magic_Man said:

Bump, make me a reasonable offer someone.

Click to expand...

Wolverine said:

I've already wore through one set of those guides, so I oil regularly and I make sure to not pull the cutter out much. Only as far as needed so it doesn't carry any slivers/grit into the guide and accelerate wear. The drill method would be awesome IMO if the carbide was long enough to not carry that debris into the guide. Kinda sucks they are made of such a soft material. Your way would really speed the process up.

Click to expand...

dall said:

i have one also but dont use it but on the 2 chains i did do i oiled them
it just sits in tool box

Click to expand...

Magic_Man said:

Holy *s-word, @dall is back !! How did I miss this ?

Click to expand...

dall said:

i have one also but dont use it but on the 2 chains i did do i oiled them
it just sits in tool box

Click to expand...

Wolverine said:

So you’re sellin??

Click to expand...

dall said:

lol id sell mine i have all the sizes of burrs to go with it

Click to expand...

dall said:

lol id sell mine i have all the sizes of burrs to go with it

Click to expand...

beaglebriar said:

Ten bucks.

Click to expand...