High Quality Chainsaw Bars Husqvarna Toys

Stihl M-Tronic Version 3.0

PogoInTheWoods

Pinnacle OPE Member
Local time
7:27 AM
User ID
1190
Joined
Apr 23, 2016
Messages
1,943
Reaction score
3,848
Location
Ohio
Country flag
Anyone here have a v.3 saw (or coil) yet? I just ordered a new coil for a 661 and it will be a 4703 v.3 coil. Also ordered a new WJ-134 for the same saw and am hoping it has the latest (green) solenoid that has been rumored to start shipping any day now. Would essentially make it a gen 3 saw without the new handle sticker.
 

PogoInTheWoods

Pinnacle OPE Member
Local time
7:27 AM
User ID
1190
Joined
Apr 23, 2016
Messages
1,943
Reaction score
3,848
Location
Ohio
Country flag
Thanks for that information. Would certainly like to see the TI you reference and hope it applies to the replacement carb I will be ordering next week. (The WJ-134 was delayed so we'll see what what actually gets ordered.)
 
Last edited:

PogoInTheWoods

Pinnacle OPE Member
Local time
7:27 AM
User ID
1190
Joined
Apr 23, 2016
Messages
1,943
Reaction score
3,848
Location
Ohio
Country flag
Any idea what the deal is with these green solenoids I've heard about?
 

PogoInTheWoods

Pinnacle OPE Member
Local time
7:27 AM
User ID
1190
Joined
Apr 23, 2016
Messages
1,943
Reaction score
3,848
Location
Ohio
Country flag
Is there a v.3 MS461 on the horizon or will the MS462 eliminate both the 441 and 461? Haven't been following any developments there if they've been posted somewhere.
 

huskyboy

Sorta a husqvarna guy...
Local time
7:27 AM
User ID
1352
Joined
May 30, 2016
Messages
10,025
Reaction score
43,448
Location
Ct
Country flag
I’m gonna guess stihl/husky will run the 372/461 side by side with the new saws till they get the teething issues worked out. Then they will probably phase the old saws out.
 

PogoInTheWoods

Pinnacle OPE Member
Local time
7:27 AM
User ID
1190
Joined
Apr 23, 2016
Messages
1,943
Reaction score
3,848
Location
Ohio
Country flag
Probably a good guess. Always thought there was a c-m option for the MS461 following in the footsteps of the 441 c-m for some reason. Maybe it was from reading about all the wishful thinking back when the 261 c-m was introduced.
 

CR888

Here For The Long Haul!
Local time
10:27 PM
User ID
452
Joined
Jan 9, 2016
Messages
2,622
Reaction score
10,578
Location
Australia
Country flag
The german MS 362 c-m III has new white solenoids ;)
Also 10mm spark plug and some minor changes.
Damn 10mm spark plug on the 362....these saws are becoming more & more like a Husky. I read the new calibration procedure on last page & it says start saw in ^ master control position and let it idle for 1minute then hold down throttle for 30 seconds. I don't have a 661 but is ^ the normal run position? And will this mean if you start your saw & it idles for a minute then pick it up to cut wood it will be in calibration mode?
 
Top