Well used 372 - wanna rebuild questions

Czed said:

https://www.google.com/shopping/pro..._8zkLyZShx3pxQ0Mgim8eow7S8Q,cdl:1,prmr:1,cs:1

Click to expand...

Scott chandler said:

That’s what i will do - i need info on how to clean up oem cylinder - i have that ball with fingers ( forgot the name) used for cleaning up cylinder and i have a regular hone. Suggestions welcomed and also where is best place to buy meteor piston rings and a good open muffler. Tell me about deleting gasket - literally just leave it off and put nothing under cylinder ?

Click to expand...

beaglebriar said:

Piston- https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/181764181950

Base gasket delete sealant- https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/172366134240

Don't try using permatex/silicone it isn't the same thing.

Muffler mod-

Click to expand...

huskihl said:

Looks like 2003

Click to expand...

huskihl said:

Yer chain is dull, slacker

Click to expand...

Scott chandler said:

Fellas if saw is stock then it should be 50mm cylinder ? And tell me where i can find year it was made and wanted to ask opinions on the 52mm pop up that hyway has. Not sure if that’s wise or no. I would like for saw to hold up but a little more power be nice. If the cylinder holds up as well as oe ? Or any mods needed like intake. If so i will just go back stock - new seals new intake rubber and new fuel oil lines and some new plastic new muffler with a new p/c or at least rings. Will leaving gasket out from under cylinder make that much difference ?

Click to expand...

Scott chandler said:

Who does porting

Click to expand...

Scott chandler said:

do you just send cylinder to them and how expensive is it ?

Click to expand...