yes in a nice piece of white pine
I don't worry about case volume to much, could always do a full circle crank.
i'm happy with it. I would have taken all the epoxy out if I needed to to get back were it was. it's a race saw, don't care how much fuel it drinks.
I didn't do a stock saw timed cut, started with a basic woods port, timed cuts 10.67, finished saw 7.99.
yes I think it lost volume, went back in and took about half of what I had left in out.
before epoxt the best cut time was 8.57.
after epoxy was...
7 pin with square ground chain
tried a reground square ground work chain
no ,I changed the tr port again, what's more important, speed or piston wash pattern?
I did get gains from the carb changes
took ya long enough. lol
I was looking for more gains, not what I would call compensating. I did it this way because of the time crunch. had I had more time I would have...
no because I would have by far to short of blow down.
yes and the same chain, only used 1
more vids loading
Separate names with a comma.