Recent content by Tractorsaw1

Look at the width on that 288! I have heard a lot about doing these but looking forward to how the super wide turns out!

Ya that part number has been back ordered for awhile - was hoping to find something i could actually get lol

what stuffers did you use/part number?

will these stuffers fit a 346 crank? Seems the 343R collar is not available/back ordered

I have been thinking about a 361 - never tried 1 maybe I am missing out...Getting ready to rebuild a ported 2152, may change my thinking

My order got screwed up, I may try to order again with 357 stuffers. I have a 2152 to completely rebuild & would be a prime canidate

thanks but I all ready had Nate order a clutch & he already had a carb. Thanks,

Looking for a Zama C3M & a clutch. Let me know if you need anything in a trade or $$. Thanks,

Ronie I like the setup, I was thinking about drilling the spikes also - what size hole did you drill them & what spacing? Great job!

While a bit scary, this was my best cylinder - raising uppers with a cut off wheel - seems like I need to start doing some more of this...

Any Jonsered chain brake covers? Sent from my iPhone using Tapatalk

I looked for awhile & I believe username arrowhead put an 038 mag cylinder on 1

Getting ready to put 1 together again myself - probably my favorite as well. Did this 1 have the 272 piston?

Holy smokes EJ - those are impressive!

@Mattyo did you use a New West big bore for the 046bb? How did it run? I'm still thinking about a 272 on a 2159 - looking for lighter