Howdy all! It's been forever since I've been on here... Anyway, I've got torched 346XP NE that has a decent scratch above the exhaust port.... I've got a couple of AM 353/350 cylinders with the 45mm bore and removable transfer covers. I've done some woods porting with those cylinders and have...
I just acquired a pair of toasted MS150T's in various stages of needing parts... This is the first saw that I have NOT been able to find any parts available online, even Bailey's doesn't have all of the parts from an MS150T on their website. Are there any dealers on here? I need a couple pistons...
I have an entire string trimmer that I am parting out. Ran good until the carburetor went bad. I have every part from this trimmer available if anyone would happen to need something from it. Listing parts of it on eBay also. Would make someone a great deal on parts if you need something.
I've had this 2-10PS for a while now and need to move it to a new home. Decent condition, has spark, will hit on a prime. Gas tank leaks at the gasket and it will need a fuel system service, I'm certain. I don't know if the Power Sharp system is missing anything, so look at the pictures. Would...
I'm going to have to double check measurements tomorrow. This piston was cheap, so worst case scenario is I'll buy a new piston for a 45mm Husqvarna 51...I think I read where that piston is compatible.
Sent from my SAMSUNG-SGH-I337 using Tapatalk
I'm working on porting a closed port Husqvarna 350 that is getting a 353 piston... Anyway, the 353 piston that I got from Farmertec has 2 rings with pins spaced on the intake side... The 350 piston had a single ring with the pin directly in the center on the intake side... I plan on really...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.