Recent content by Steve670

I'd say search for a good used oem crank. Can't comment on the aftermarket units, I've never used one before.

Check with Shaun, The Carby Doctor in Melbourne. Let me know if you need his number.

Had this oleo mac on the bench, just needed a really good clean and two missing bolts replaced. Made up a couple of adapters out of 8mm nuts so I can run my Stihl bars.

365 special getting a new piston, clutch side seal and oring, a/v springs and a brake handle.

81cc I think. Spewin it got damaged in transit.

Oleo mac 284, a bit curious to see how this Italian goes, gotta find an air filter first.

Nice work bloke. Long live the green machines

May she rest in peace

Solo 644sp, at $45 I had no choice but to give it a good home.

Solo 662, shindaiwa 488 and Stihl 031 or 032. Solo and the shindaiwa run, the Stihl most likely needs carb work.

Clutch needs to be on there when pressure and vacuum testing.

Shindaiwa 488

Stihl 039 got a new piston, bearings, seals, brake handle, just waiting for a muffler to get here. Was filthy when I got it and come up ok with good clean.

Right now it's 6.30 am Sunday, I'm hoping everything went ok, knowing Brewz there should be a heap of pics and vids up by now!

Been looking for an 044 fuel tank/handle and was getting a bit depressed about putting a chinga fuel tank on it. Was about to order a huztl off ebay when I scrolled a bit further and found an oem, got it for $31 + $14.50 postage.