Recent content by silverpsd06

Does anyone know how to remove the limiting tabs on these? Doesn't seem to have enough meat to get a drywall screw to pull the plastic piece away from the metal like on older saws. Is there a tool to use? Never had the red ones whip me like this.

I have not investigated that but I will take a look at them. I'd assume they're fine since it's all OEM

I think I have found the solution to my issues, going to experiment with plugging one of the jets inside the carburetor. Will report back carburetor is a WG-12A. Filters aren't new but definitely not dirty enough to cause this issue, both needles will work through full range of leanest setting...

Pressure tested the carb to 15PSI, saw was a runner before any mods, has a cast aluminum muffler (clip on and has been modded albeit ugly). Taken carb apart, removed needles and brake cleaned through them no change. Is there a bypass circuit in these carbs? It's a Walbro.

I have woods ported a MS880 and swapped coils to the unlimited 088 coil.. After assembly the saw will not lean out on the high needle, high needle will respond with more fuel but nothing less even seated snug. Low responds normally. I have tried adjusting timing from slightly advanced to...