Recent content by radio

Thanks Ray for your quick response! Husky used to have the poulan stuff, it's got to be somewhere! LOL If I ever find it I'll send it your way. It's disiappointing Husky does not have the WM for a current product. Echo has never given them out, not sure how people have gotten some ECHo SMs...

This is going to be a busy week/weekend for me. I have 3 Echo trimmers gt-200R, gt-2000 Type 1e and SRM2100 Type 1e. Not sure what the Type 1e is but all the ipls look very similar. I need a workshop manual for these machines. TY

Lastly I have a husqy 150bt with some light aluminum transfer on the cylinder and a bit of scraping on the piston. I'll clean the cylinder and got a Golf piston to put in. I'd like the full workshop manual for the 150bt. Thank you in advance.

I could use a workshop manual for the Poulan 2125. Also can't find Poulan IPLs on Husqy's site, only the latest saws.

Need Echo cs-361p workshop manual. Looks like the whole thing needs to be torn down to replace fuel lines, ugh. BTW, The saw sat over this winter and didnt to it's normal start on 1st or 2nd pull. This saw has never seen anything but TruFuel or Husqvarna or VP Fuels and yet the fuel filter was...

<deleted>

I always liked 34lg and used 5/32 files for it.

Each ... updated

I've got three 100' rolls of Oregon 21BPX. This is semi chisel .325 pitch chain in .058 gauge. $199 each plus shipping. Paypal FF or Postal MO. I can break up a box and sell partial lengths if there is enough interest. $60 for 25', $110 for 50'.

Thanks @USMC615 I got the user's manual from Honda's website. I was looking for the service manual for the mower but an engine manual will do! Thank you @ray benson ! After a couple hours of searching I did find some other GCV160 service manuals but the one Ray dropped here is the most...

Looking for one ... Honda HRT216TDA Shop Manual

My bad, those bars are made by Sugihara. The Sugihara light bars have always been heavier than the Tsumura ones. Not sure if Husqvarna gets a differently spec'ed bar from Sugi.

Those are Tsumura Light bars made for Husqvarna so will probably be heavier than the Tsumura you already tried. EDIT: I looked at the pic of the bar too quickly. The new Husqvarna X-Tough Light bars are made by Sugihara.

I have some Oregon 3/8 x .063 and can spin up a loop or two - 75LGX, 75LPX, 75CL (square), 75CK (square semi-skip).