High Quality Chainsaw Bars Husqvarna Toys

Recent content by muggy461

  1. muggy461

    Bolt On MS461 Scrench Holder

    Havent used it yet while regularly cutting, but I did have it on while milling some black walnut and it held up just fine. I was worried at first about that myself, but it turned out to be a nice snug fit. Tight enough to not fall out but not enough to have trouble taking it out. Id like to see...
  2. muggy461

    Bolt On MS461 Scrench Holder

    Not looking to sell these just yet if at all, but I would like to get some feedback and gauge interest. I know it's not for everyone, as not everyone uses their saws the same
  3. muggy461

    Bolt On MS461 Scrench Holder

    Finished up my 461 build a few months back. Got the saw blown up from a friend for free with under 5 hours on it since new. Nothing crazy just a mild port and polish, ported stock exhaust, painted covers, custom starter badge. Being that I'm going to school for mechanical engineering, I had to...
  4. muggy461

    1986 Trx250r build thread

    Leaving the paddles on? Or will it be a track bike?
  5. muggy461

    Looking to get into milling

    +1 for the winch!
  6. muggy461

    462 Cover

    I'll give that a shot tomorrow, I should have access to a new 261 cover at work
  7. muggy461

    462 Cover

    Finally wrapped up my ms461 rebuild. Left it stock, although I plan on doing a simple port/polish, ported muffler, unlimited coil swap, etc in the future. Has anyone tried to put the newer style 462 bar cover with the captive nuts on the 461? Is it possible at all? Willing to swap any parts...
Top