Just ran into this. I'm trying to put a 32" Tsumura Light and Tough on a Stihl 461. The bar is almost adjusted out as far as it will go. When just spinning the chain by hand in the same direction the engine would spin it, it wants to climb out of the bar grove on the top of the bar. I'm...
I've had both a 16" Rollomatic E and a Sugihara 16" light weight bar on my 260. Didn't weigh them, but I wouldn't be surprised if the Rollomatic E wasn't lighter. Not near the quality of the Sugihara, but lighter maybe...
Trying to find a captive nut clutch cover that was used on 261 and 362 for a short time before Version 2 came out with the smaller clutch cover. Prefer NOS or really clean. I'd also buy the bar studs that go with this setup if you got them. thanks
I use a bar tip grease gun and run a line of grease around the groove in one of the filter halves. Also run a line around the part that matches to carb venturi. Seems to really help a lot
Got the day off, able to get some projects marked off the list! Here's the shop. We lived in the shop for 4 years while building the house, so that explains the heat/air and bathroom.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.