Sorry but I leave in France and we talk in metric unit .
I have try with 0.8 mm mig wire and it is to thin for me.
I have try with 1mm tungsten, 15 to 20 amp of dc courant and it wasn't good
I would like to find 1mm or 1.5 mm tig rod but in France it is very hard
I perhaps have find a...
Thanks RI
But i can say that it's very difficult to weld it.
The stainless steel of the stihl muffler is thin... very thin
I have made a muffler mod on a 661CM
I will post on the forum one time that I have test it
I guys
I have made my 261cm muffler mod
Tig weld
Time cut original muffler 7 seconds
Time cut muffler mod 5 seconds
In same conditions and wood
Now I am going to chearch how to send you pics
Can you say me what max RPM you adjust the carb with muffler mod?
Mine is 10 or 15 tanks use
and run about 13500 RPM
I wouldn't broke the engine with to hi rpm or to lean adjust
hello every body
I send you pics of my muffler mod on my CS 2511 t
the exhaust has been cut as you will see in the photos.
this to remove the inner part containing the honeycomb catalyst.
I removed the catalyst to prevent its fouling with carbon gases do not change the flow of gas over time...
I friend
I am looking for the workshop manual of the echo cs 2511 ?
In french if possible
That is an extra saw
I have a 12 inch 1.3mm oregon bar with 1/4 inch chain and it works very well
Thanks a lot
Jo
Hello at all
I would ask every body about return of expérience of muffler mod on ms 261 Electronic ( or not Electronic )
The first modif have 6 or 7 years now
So What about the gain of power after long time of use ?
What about éventual fail or broken engine ?
Or else news
Thanks a lot for...
Hello every body
Thanks a ot for you make on the forum
It's super
Is some one have got the diagram parts of stihl ms 261 c-m please?
I chearch it
Thanks à lot
Jo from france
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.