High Quality Chainsaw Bars Husqvarna Toys

Recent content by Gravedigger

  1. G

    Archer ripping chain.

    3/8. 050-114 link . Two loops for $71.90 on the big auction site delivered.
  2. G

    Archer ripping chain.

    I️ just ordered 2 loops to use in my chainsaw mill. The good reviews of regular chain thought I’d try some. Anybody used the archer ripping chain? I’ve never used ripping so I️ won’t be able to compare it to.
  3. G

    Framacheck Ms250 truck saw

    Any update on the ms250. Been considering one.
  4. G

    Gravedigger's 660

    Ordered BB top end.
  5. G

    Makita 6401 w/BB melted impluse line

    Finally ran 4 tanks of fuel through it one after another cutting up 4 ash trees into firewood. Almost to 2 cords. Everything is running well.
  6. G

    Gravedigger's 660

    Still haven't ordered a new piston. Should I just order a BB cylinder and piston to replace farmer tec or just get a new piston ? Looking at a new west products from @Definitive Dave . Should I consider something else? I'm planning on using the saw for milling and firewood. Probably only...
  7. G

    660 clone build

    Mine was running 40:1 bel ray avgas Picture of plug when crank went.
  8. G

    064 hose. Thread evolved need bing carb replacement

    I might take you up on that if you can teach me so I understand turning better.
  9. G

    064 hose. Thread evolved need bing carb replacement

    Gas tank vent not working. Is there vent to get instead of the screw in tubing from OEM? Using the tonight and would run well for about a quarter tank and quite. Open tank and release vacuum. Runs again. I put it away after that.
  10. G

    660 clone build

    The new crank came from HL Supply. The original crank bearings seized when the stopped running. I think it saved itself from more damage.
  11. G

    660 clone build

    I've been fishing last week and don't have it back together. Need to order piston as it broke the skirt. Debating on replacing top end also. The crank is definitely a lot better quality.
  12. G

    Care To Guess What Brand This Jug Is?

    Isn’t NWP , New West Products
  13. G

    Gravedigger's 660

    Yes I installed the HL Supply crank using your tool and everything went very smooth. The picture is the new crank in the case. @Mattyo
  14. G

    Gravedigger's 660

    Should I get a Mako or Hyway piston or splurge for a Meteor or other piston?
  15. G

    Gravedigger's 660

    Installed crank in case. Found the failure due to crank bearing going when I went to put piston on crank. Piston skirt is missing.
Top