Does anyone have a functional cylinder for a 306a they’d be willing to donate, swap, or sell. Only interested in one that has the chrome lining intact and complete. Thanks, jerry
Does anyone know how to pressure test a poulan 306a? Can’t get any pressure using my mityvac
Started tearing it down to attempt to discover why. Took the oil pump cover off; mostly for cleanup. Then used my compressor to push some air in through the modified spark plug I fabricated. Lo and...
Reed petals look tight. Reed block has no cracks I can see.
After dunking in water I discovered it was leaking between carb and reed. Took it down and found the carb gasket had slipped when some idiot, me, reinstalled after rebuild. Got that fixed and now it runs well until you turn it...
Hey guys, posted this on the poulan thread but seems that site may have dried up. So decided to post it here on a live site. Hopefully someone can help this OF.
Got a 306a I can sell if I can get it sorted out.
Got and rebuilt it in ‘12. Installed new seals at same time. Used it a few times then...
Got a 306a I can sell if I can get it sorted out.
Got and rebuilt it in ‘12. Installed new seals at same time. Used it a few times then set it on the shelf since then. Rebuilt carb again in ‘19.
Got offer for saw recently and again wouldn’t start so again rebuilt the carb, a tillotson HS59a...
Haven’t taken it down yet but looked good when last time installed when I replaced pc
Got to sort through my junk for another handle
Thanks for response
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.