I get good service from them also. The reason the 025 carb wouldn’t run the saw is the suction port on the intake side of the carb. It should be a wt-215. Look at the 180 zama carb & the 025. The hole is 180 degrees off. It usually has an indention so you can drill it. Don’t plug the other hole...
I did a 026 for a friend also & put a new factory Walbro carb on it. Mine was very close to yours. I did the normal 4stroke test & plug checks. After a year later it is going strong without issues.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.