Nice! Now, when you get another 300-400 you can justify, send it to randy at mastermind work saws, for porting timing ect.... I ran my 462 stock for a couple days then had randy port it.....
Runs a 36” bar with authority! Or show off with anything less. It’s amazing!
Sent from my...
I can’t believe it.....while I’m waiting for randy to get to my 462 i switched the rim sprocket on my 261 so I could use a larger bar for dropping a big tree.
The 261 mastermind saw pulled a 28” bar 3/8, full chisel skip.....took the first 10 sec to get it settled down in the cut, but it...
I got about 10 tanks though the new 261 that randy modded. All I can say is wow. I’m new to cutting with probably only a couple hundred hours on saws and mostly, on a 271. Bought the 261 stock ran 2 tanks though ...ya ok it’s lighter and a bit better than the 271. Immediately sent it to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.