FOUND IT Husqvarna 444SE

[jakeshi]

Been looking for a long time and finally found one. KS 939/3D cylinder. This saw has the double thin ring.

 

[wcorey]

Very, very nice, I've been looking for a long time too, haven't been so lucky.
44's everywhere, that extra 4 is elusive...

 

[Johnmaddux541]

Very, very nice, I've been looking for a long time too, haven't been so lucky.
44's everywhere, that extra 4 is elusive...

Was this the one on eBay?

 

[jakeshi]

A while back yes.

 

[Johnmaddux541]

A while back yes.

Beautiful saw!!

 

[dustinwilt68]

Can I ask how many CC these are, beautiful looking saw!

 

[wcorey]

44cc, of course...

 

[jakeshi]

yep 44 it is. The big daddy of the chassis. I believe this saw starts and runs better than any Husky I have but this is the only thin ring saw I have so that may be the difference.

 

[David Young]

yep 44 it is. The big daddy of the chassis. I believe this saw starts and runs better than any Husky I have but this is the only thin ring saw I have so that may be the difference.

Piston pic?

 

[jakeshi]

Before cleanup.

 

[David Young]

Wow!
Super jealous

I got to run one. It’s an impressive saw

 

[Jughead]

I been lucky enough to get a 444 cylinder from Europe a while back to swap to a 44 that I bought a while back.when it arrived it was a KS 939.finally located a NOS 444 piston on ebay earlier this week but it is a single thick ring.will it still work?were the early cylinders chrome plated and later ones nicasil?

 

[jakeshi]

I believe you would be fine with a single ring. My cylinder looked to be chrome plated.

 

[Jughead]

I'm sure mine is chromed.oh well.we'll find out shortly.just have to Helicon the top cover hole and put a stud in.