Continuation of my lathe fund drive.
Well I did a highlight of my build on here on OH PEA EEEE
http://opeforum.com/threads/cobbled-288-fighting-me-every-step-of-the-way.12710/#post-661728
I brought it down to the cases. New nachi bearings oem gasket kit except I forgot to put that pesky base gasket in. So the compression is 175. :rock:
I rewired it gave it a carb kit husky fuel filter and put in some after market fuel line.
This is all oem except the fuel line and nachi bearings.
I put the best covers I had on it.
The seam on the gas tank was open. The screws were not tight. I cleaned it used seal all and tightened the screws. Hasn’t been a problem.
I’m asking 400 pho plus shipping Pics coming
Well I did a highlight of my build on here on OH PEA EEEE
http://opeforum.com/threads/cobbled-288-fighting-me-every-step-of-the-way.12710/#post-661728
I brought it down to the cases. New nachi bearings oem gasket kit except I forgot to put that pesky base gasket in. So the compression is 175. :rock:
I rewired it gave it a carb kit husky fuel filter and put in some after market fuel line.
This is all oem except the fuel line and nachi bearings.
I put the best covers I had on it.
The seam on the gas tank was open. The screws were not tight. I cleaned it used seal all and tightened the screws. Hasn’t been a problem.
I’m asking 400 pho plus shipping Pics coming