S&S_Work_Saws's latest activity
-
S&S_Work_Saws replied to the thread John deere motor swap.I got the 24hp platinum v twin set on the chassis. Unfortunately none of the mounting hole options in the chassis will line up with the... -
-
S&S_Work_Saws replied to the thread John deere motor swap.Thanks for the replies everyone. So the shaft length and diameter is the same on both motors. I got the new motor running on a little...
-
-
Good afternoon gents So I've got a deere Z225 Zero turn mower. Fairly low hours at around 400ish. It's a decent little 48" mower. The...
-
S&S_Work_Saws replied to the thread Tuning advice.These dolmars sure like to be at about 95 or 96 on the exhaust though. I'll try to lean it out a little and see what I get. Thanks
-
I just finished up another dolmar 7910. I can't for the life of me get it tuned just right. I've encountered this issue before and cant...
-
S&S_Work_Saws replied to the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread?.My family still live in Nixa. They said it got pretty wild for a while.
-
S&S_Work_Saws replied to the thread Lathe questions??.My jet BD-920N should be the same thing as the grizzly G4000 I believe. Should be able to use that one. Thanks!!
-
S&S_Work_Saws commented on domurphy93's profile post.Service manual for 4 stroke FS131 please?? Thank you
-
S&S_Work_Saws replied to the thread Lathe questions??.Does anyone have a prefered place online to purchase lathe parts and tooling from?? I'm wanting to upgrade my 2 bolt cross slide hold...
-
S&S_Work_Saws replied to the thread 395xp carb options.The current location of mine. I don't need it's bad attitude rubbing off on all the other saws 🤣🤣🤣
-
-
S&S_Work_Saws replied to the thread 395xp carb options.I may have one really soon. After a lot of thought and consideration the only conclusion I can draw is that this particular 395xp has...
-
S&S_Work_Saws replied to the thread 395xp carb options.I finally got it fixed about 15 minutes ago. Used parts out of a 390 carb. Went ahead and did a vacuum/pressure test on it while it was...
-
S&S_Work_Saws replied to the thread 395xp carb options.Well this is what I've found so far...the impulse line was good. The carb however is suspect but I've never seen a diaphragm actually...
-
-
I agree with the impulse diagnostic. Check to make sure the barb into the cylinder isn't clogged, someone could have used sealant on the...
-
S&S_Work_Saws replied to the thread 395xp carb options.I'll recheck all of my fuel and impulse lines in the morning. I know it's got to be something simple that I've just over looked.
