Recent content by numnutz6383

Thanks. I should've mentioned I already did all that you mentioned. First I ran a torch tip cleaning wire through then I drilled out the main jet a teeny bit with a 0.35mm drill bit. It improved the surging to a small degree. In hindsight I think I also have an intermittent hydrolocking problem...

Howdy all, I'm hoping to get some advice with a malfunctioning Murray PW3200 pressure washer (which appears to be a rebranded Husqvarna PW3200) with a B&S CR059 engine. I'm not new to small engines and I can and do wrench on them quite a bit, albeit mainly two stroke. A little background on the...

Warning, I'm cross posting from other forums so this is a LONG post. So I have this SXLAO that I picked up a few months ago. It came to me running, but not well. Previous owner replaced the fuel line, filter, duckbill valve, and if I remember correctly, did a carb refresh. Since then I found...

These OG Jonsered had 10mm bar studs, from what I've been told. I should probably measure them to confirm they haven't been changed over the years to the large mount husky studs.

Hmm, I'm not particularly good at reading the Oregon bar codes. The new ones I can figure out but this one is a foreign language to me. Quick Google search shows that it's a d196 though.

Looking for a D024 bar for my JRed 910. I know that I can take a large mount husky bar and modify, but if I can find one without modifying anything, I'd rather do that. Something like 30" or 32" would do.